Baked Pumpkin Cheesecake—Prototype 15:
 
This November 2026 update features a crust update—more All-Bran for better stability.
 
3-Cheese Blend (1CT-1NC-1YG):
Prepare ahead of time 16 ounces of yogurt cheese, derived from one 32-ounce container of nonfat yogurt. If the resulting yogurt cheese falls below 16 ounces, add back enough of the whey (that was strained out from the yogurt) to make up the difference. To this yogurt cheese combine 16 ounces of whipped, lowfat cottage cheese and 16 ounces (two 8-ounce packages) of softened Neufchatel cheese ("light cream cheese").

Grease a 9 1/2" (or 9") springform pan, but do not wrap foil around it yet (see below).

Crust:
4 oz. melted, white chocolate
8 oz. (1 cup) 3-cheese blend (see above)
1/4 cup granulated sugar
1/4 cup brown sugar
2 teaspoons pumpkin pie spice
1/2 teaspoon vanilla
3 oz. All-Bran, ground up

Place the resulting mixture in the greased pan and pre-bake without tub at 300 degrees for 30 minutes, then remove from oven and cool down at room temperature (for at least 30 minutes).

Batter:
1 cup granulated sugar
40 oz. (5 cups) 3-cheese blend (see above)
14 oz. pumpkin butter
2 teaspoons vanilla
2 1/4 teaspoons xanthan gum
6 eggs

Expect close to 8 cups of the resulting batter, but do not add this to the pan all at once. Rather, this needs to be done in four installments. Wrap the pan in foil (or—as an alternative—use a cheesecake pan bath wrap) just before adding the first batter installment (to minimize the foil's disturbance and therefore its leakage risk, do not put it on any earlier).

For each of these four installments, gently scoop about 2 cups of batter into the pan, fully covering the surface (here's a tip—scoop small amounts of batter around the edge of the pan, letting this batter flow towards the middle on its own), and then bake this pan with its contents for 55 minutes—at 325 degrees for the first two installments, and at 300 degrees for the remaining two. For the first three installments, bake with the pan in a tub filled with at least 1/4 to 1/2 inch of boiling water, but (to reduce spillage risks) do not fill the tub all the way at this point, because the whole tub-and-pan assembly is going to need to be removed from the oven (in order to comfortably add contents to the pan) between installments. However, fill up the tub generously with boiling water just before the final baking installment.

Afterward, shut the oven off, and leave its door slightly ajar, with the cheesecake still inside—and in the tub—for an hour. Next, remove the cheesecake from the oven and tub. Continue to cool it down at room temperature for another two hours. After doing so, remove the cheesecake from pan and refrigerate.

Pumpkin Cheesecake—Prototype 15

Two of these for Thanksgiving 2026—one for my workplace, the other for my cousins.
 

Back to my bushy homepage